User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration

4Motion 422 System Manual

 “Configuring the SNMP Manager” on page 422

 “Configuring the Trap Manager” on page 424

4.3.13.1 Configuring the SNMP Manager

To enable 4Motion configuration over SNMP, you are required to first configure

the SNMP Manager. You can configure up to five SNMP Managers for the 4Motion

system. This section describes the commands to be executed for:

 “Adding an SNMP Manager” on page 422

 “Deleting an Entry for the SNMP Manager” on page 423

 “Displaying Configuration Information for SNMP Managers” on page 424

4.3.13.1.1 Adding an SNMP Manager

You can configure upto five SNMP Managers. To add an SNMP Manager, run the

following command:

npu(config)# snmp-mgr [ReadCommunity <string>] [ReadWriteCommunity

<string>]

You can display configuration information for existing SNMP Managers. For

details, refer Section 4.3.13.1.3.

NOTE

An existing SNMP Manager entry cannot be modify. To modify the parameters of an SNMP

Manager, delete the entry and add a new entry with the required parameters.

IMPORTANT

An error may occur if you have specified:

 More than five entries for the SNMP Manager

 Duplicate entries

Command

Syntax

npu(config)# snmp-mgr [ReadCommunity <string>] [ReadWriteCommunity

<string>]

Privilege

Level