User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 416 System Manual
After you have enabled collection and storage of performance data is fetched every
quarter of an hour.
NOTENOTE
When you enable collection of performance data collection, the data is stored in a file called,
prf_yyyymmddhhmm.xml.gz in the path, TFTP/boot/Management/Performance Manager. It is
recommended that you periodically make a backup of these files on an external server.
IMPORTANT
An error may occur if run this command when you are operating the NPU in the Transparent mode
and want to enable performance data storage and collection for the following WiMAX signaling
protocol groups:
 Service Flow Authorization functionality
 Data path functionality
 AAA client functionality
 Authenticator function
 Context function
 DHCP proxy functionality
 DHCP relay functionality
 DHCP server functionality
 MS state change functionality
Command
Syntax
npu(config)# group enable
{pmNpuBckhlPort | pmNpuMgmtPort | pmNpuCascPort
| pmAuPort | pmNpuIntMgmtIf | pmNpuExtMgmtIf | pmNpuLclMgmtIf |
pmNpuBearerIf
| pmSfa | pmDatapathFn | pmAaaClient | pmAuthenticator |
pmContextFn
| pmDhcpProxy | pmDhcpRelay | pmDhcpServer |
pmMsStateChangeFn}
npu(config)# group enable au {
pmBsDeRegistration | pmBsIntegrity |
pmBsMobility | pmBsNetworkEntry | pmBsTraffic | pmBsUtilization |
pmBsGeneral | pmbsallmsbasicmode | pmbsspecificmsadvancedmode}
Privilege
Level
10