User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 394 System Manual
4.3.10.17.2 Displaying Configuration Information for ASN-GW Keep-Alive
Parameters
To display the ASN-GW keep-alive parameters, run the following command:
npu# show keep-alive
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[asnGwKeepAliv
eTmr <integer
(10-1000)>]
The period ln seconds
between polling sessions.
asnGwKeepAliveTmr x 1000
(value in milliseconds) cannot
be lower than
asnGwKeepAliveRespTmr x
(asnGwKeepAliveRtxLmt +1).
Optional 60 10-1000
[asnGwKeepAl
iveRtxLmt
<integer
(1-10)>]
Maximum number of retries if
asnGwKeepAliveRespTmr
has expired without getting a
response.
Optional 3 1-10
[asnGwKeepAliv
eRespTmr
<integer
(100-10000)>]
Time in milliseconds to wait
for a response before
initiating another polling
attempt or reaching a
decision that the polled entity
has failed (if the maximum
number of retries set by
asnGwKeepAliveRtxLmt has
been reached).
Optional 500 100-10000
[asnKeepAliv
eEnable
<enable|disa
ble>]
Enable/Disable the ASN-GW
keep-alive mechanism.
Optional disable
 enable
 disable
Command
Modes
Global configuration mode
Command
Syntax
npu# show keep-alive