User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 389 System Manual
4.3.10.16.3 Terminating the PHS Rules Configuration Mode
Run the following command to terminate the PHS rules configuration mode:
npu(config-phsrule)# exit
[mask <value>] Indicates the PHSM, which
contains the bit-mask of the
PHSF with the bits set that is
to be suppressed.
Mandatory N/A String This
parameter is of
format
"0x000000".
Here Octet(x),
x=3 bytes,
each Byte will
represent two
characters
when used as
string like in
xml file.
[verify
<value>]
Indicates whether the PHS
header is to be verified.
Optional 0 (No)
 0: Indicates
that the
PHS
header
should be
verified.
 1: Indicates
that the
PHS
header
should not
be verified.
[size <value>] Indicates the size in bytes of
the header to be suppressed.
Mandatory N/A 0-20
Command
Modes
PHS rules configuration mode
Command
Syntax
npu(config-phsrule)# exit
Privilege
Level
10
Command
Modes
PHS rulesconfiguration mode