User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 381 System Manual
4.3.10.15.4.8.5Deleting Destination Ports
Run the following command to delete one or all destination ports
npu(config-clsfrule)# no dstport [<start-port> <end-port>]
Command
Syntax
npu(config-clsfrule-dstport)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-destination port configuration mode
CAUTION
Specify the start and end port numbers if you want to delete a specific destination port. Otherwise
all the configured destination ports are deleted.
IMPORTANT
An error may occur if you provide an invalid value for the start-port and end-port parameters.
Refer the syntax description for more information about the appropriate values and format for
configuring these parameters.
Command
Syntax
npu(config-clsfrule)# no dstport [<start-port> <end-port>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<start-port> Denotes the starting value of
port range to be deleted.
Optional N/A 1-65535
<end-port> Denotes the end value of port
range to be deleted.
Optional N/A 1-65535