User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 380 System Manual
npu(config-clsfrule-dstport)# port-enable
You can also run this command to enable a destination port range that is
currently disabled. For details, refer to “Disabling the Destination Port Range” on
page 380.
4.3.10.15.4.8.3Disabling the Destination Port Range
You can run the following command to disable the destination port range that is
currently enabled:
npu(config-clsfrule-dstport)# no port-enable
4.3.10.15.4.8.4Terminating the Destination Port Configuration Mode
Run the following command to terminate the destination port configuration mode:
npu(config-clsfrule-dstport)# exit
Command
Syntax
npu(config-clsfrule-dstport)# port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination port configuration mode
IMPORTANT
To enable this destination port range, run the following command:
npu(config-clsfrule-dstport)# port-enable
For details, refer to
“Enabling the Destination Port Range” on page 379.
Command
Syntax
npu(config-clsfrule-srcport)# no port-enable
Privilege
Level
10
Command
Modes
L3 Classification rules-destination port configuration mode