User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 371 System Manual
 Configure the address mask (refer to Section 4.3.10.15.4.6.2)k
 Disable the destination address (refer to Section 4.3.10.15.4.6.3)
After you execute these tasks, you can terminate the destination address
configuration mode (refer to Section 4.3.10.15.4.6.4) and return to the
classification rules configuration mode.
4.3.10.15.4.6.2Configuring the Address Mask
Run the following command to configure the address mask for the destination
address.
npu(config-clsfrule-dstaddr)# config [addr-enable] [addr-mask
<value>]
IMPORTANT
An error may occur if you provide an invalid destination IP address. Refer the syntax description for
more information about the appropriate values and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# dstaddr <ipv4addr>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ipv4addr> Denotes the IPv4 address of
the destination address for
which the configuration mode
is to be enabled. If you want
to create a new destination
address, specify the value for
the new destination address.
The destination address
configuration mode is
automatically enabled.
Mandatory N/A Valid IP
Address
Command
Modes
L3 Classification rules configuration mode