User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 366 System Manual
4.3.10.15.4.5.1Enabling the Source Address Configuration Mode\ Creating a New
Source Address
To configure the parameters for a source address, first enable the source address
configuration mode. Run the following command to enable the source address
configuration mode. You can also use this command to create a new source
address.
npu(config-clsfrule)# srcaddr <ipv4addr>
If you use this command to specify a new source address, the configuration mode
for the newly created source address is automatically enabled, after which you
can execute any of the following tasks:
 Configure the address mask (refer to Section 4.3.10.15.4.5.2)
 Disable the source address (refer to Section 4.3.10.15.4.5.3)
After you have executed these tasks, terminate the source address configuration
mode to return to the service classification rule configuration mode (refer to
Section 4.3.10.15.4.5.4).
IMPORTANT
An error may occur if you provide an invalid source IP address. Refer the syntax description for
more information about the appropriate value and format for configuring this parameter.
Command
Syntax
npu(config-clsfrule)# srcaddr <ipv4addr>
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<ipv4addr> Denotes the IPv4 address of
the source address for which
the configuration mode is to
be enabled. If you want to
create a new source address,
specify the value for the new
source address. The source
address configuration mode
is automatically enabled.
Mandatory N/A Valid IP
Address