User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 364 System Manual
4.3.10.15.4.4.4Terminating the Protocol Configuration Mode
Run the following command to terminate the IP protocol configuration mode:
npu(config-clsfrule-protocol)# exit
4.3.10.15.4.4.5Deleting Protocol Lists
You can, at any time, run the following command to delete all protocol lists:
npu(config-clsfrule)# no ip-protocol
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<number of
protocols(1-6)
>
Indicates the number of
protocol lists to be disabled.
In the current release, only
one protocol can be enabled
per classification rule.
Mandatory N/A 1
<protocol1>
[<protocol2>]
[...]
Indicates the protocols to be
disabled. You are required to
specify at least one protocol
that is to be disabled.
In the current release, the
single previously enabled
protocol should be defined.
Mandatory N/A 0-255
Command
Modes
L3 Classification rules-IP protocol configuration mode
Command
Syntax
npu(config-clsfrule-protocol)# exit
Privilege
Level
10
Command
Modes
L3 Classfication rule-IP protocol configuration mode