User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 362 System Manual
2 Enable/disable protocol lists (refer to Section 4.3.10.15.4.4.2 and
Section 4.3.10.15.4.4.3)
3 Terminate the protocol configuration mode (refer to Section 4.3.10.15.4.4.4)
In addition, you can, at any time, delete an existing protocol list (refer to
Section 4.3.10.15.4.4.5).
The following example illustrates the (sequence of) commands for enabling the IP
protocol configuration mode, enabling IP protocol 100, and then terminating the
protocol lists configuration mode:
npu(config-clsfrule)# ip-protocol
npu(config-clsfrule-protocol)# protocol-enable 1 100
npu(config-clsfrule-protocol)# exit
4.3.10.15.4.4.1Enabling the IP Protocol Configuration Mode
Run the following command to enable the IP protocol configuration mode.
npu(config-clsfrule)# ip-protocol
You can now enable or disable a protocol list (refer to Section 4.3.10.15.4.4.2 and
Section 4.3.10.15.4.4.3).
4.3.10.15.4.4.2Enabling Protocol Lists
After enabling the protocol configuration mode, run the following command to
enable one or more IP protocol lists:
npu(config-clsfrule-protocol)# protocol-enable <number of
protocols(1-6)> <protocol1> [<protocol2>] [...]
Command
Syntax
npu(config-clsfrule)# ip-protocol
Privilege
Level
10
Command
Modes
L3 Classification rules configuration mode