User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 348 System Manual
4.3.10.15.3.3.4Configuring Uplink/Downlink Classification Rule Names
After enabling the service flow configuration mode, run the following commands to
configure up to a maximum of 6 uplink and 6 downlink classification rules:
npu(config-srvcprfl-flow)# ulclsf-rulename <num_of_rule_names
(1-6)> <rulename> [<rulename>] [...]
npu(config-srvcprfl-flow)# dlclsf-rulename <num_of_rule_names
(1-6)> <rulename> [<rulename>] [...]
After you have executed these tasks, you can terminate the service flow
configuration mode, and return to the service profile configuration mode
(Section 4.3.10.15.3.3.6). For more information about configuring classification
rules, refer “Configuring Classification Rules” on page 355.
Command
Syntax
npu(config-srvcprfl-flow)# ulclsf-rulename <num_of_rule_names (1-6)>
<rulename> [<rulename>] [...]
npu(config-srvcprfl-flow)# dlclsf-rulename <num_of_rule_names (1-6)>
<rulename> [<rulename>] [...]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<num_of_rule_n
ames (1-6)
>
Indicates the number of
uplink/downlink classification
rules to be created
Mandatory N/A 1-6