User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 341 System Manual
4.3.10.15.3.3.2Specifying Service Flow Configuration Parameters
After enabling the service flow configuration mode, run the following command to
configure the parameters for this service flow:
npu(config-srvcprfl-flow)# config ([flow-type <type (1)>] [cs-type
<type (1 | 4)>] [media-type <string>] [uldatadlvry-type
<type(0<UGS> | 1<RTVR> | 2<NRTVR> | 3<BE> | 4<ERTVR> | 255<ANY>)>]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
flow [<flow-id
(1-255)]
Denotes the flow ID of the
service flow for which the
service flow configuration
mode is to be enabled. If you
are creating a new service
flow, specify the service flow
ID of the new service flow.
The configuration mode is
automatically enabled for the
new service flow.
Mandatory N/A 1-255
[ServiceGrpA
lias
<srvc-grp-al
ias>]
Indicates the Reference
Name for an existing service
group to be used by the
service flow.
VPWS-QinQ and VPWS
Transparent Service Groups
are applicable only for
Service Flows of the Default
Service Profile.
Mandatory
when
creating a
new flow
N/A An existing
Service Group
Alias.
[ServiceIfAl
ias
<string>]
Indicates the Reference
Name for an existing QinQ
service interface.
Applicable only if the
assigned Service Group is of
type VPWS-QinQ (in a
VLANCS Service Flow of the
Default Service Profile).
Mandatory
when
creating a
new flow,
only if the
type of the
specified
ServiceGrpAl
ias is
VPWS-QinQ.
N/A An existing
QinQ Service
Interface.
Command
Modes
Service profile configuration mode