User Manual

Chapter 4 - Operation and Administration Using the CLI Using the Command Line Interface for 4Motion System
4Motion 120 System Manual
4.1.4 Using the CLI
To help you use the CLI, this section provides information about:
 “Using Control Characters” on page 120
 “Using the CLI Help” on page 121
 “Using the History Feature” on page 121
 “Using Miscellaneous Commands” on page 122
 “Privilege Levels” on page 122
4.1.4.1 Using Control Characters
Control characters refer to special characters that you can use to recall or modify
previously-executed commands. The following table lists the control characters to
be used for executing commands on the CLI:
| Indicates the OR conditional
operator that is used between two
or more parameters. The
presence of this parameter
indicates that only one of the
parameters separated by the I
conditional parameter should be
specified in the command.
npu(config)# group enable
{pmNpuBckhlPort | pmNpuMgmtPort
| pmNpuCascPort | pmAuPort |
pmNpuIntMgmtIf | pmNpuExtMgmtIf
| pmNpuLclMgmtIf | pmNpuBearerIf
| pmSfa | pmDatapathFn |
pmAaaClient | pmAuthenticator |
pmContextFn | pmDhcpProxy |
pmDhcpRelay | pmDhcpServer |
pmMsStateChangeFn}
This command is used to specify the group
for which performance data collection and
storage is to be enabled. The | conditional
operator indicates that only one parameter
should be specified.
NOTE
In this document, all discrete values are specified in boldface, and all user-defined values are not
bold.
Table 4-4: Conventions Used in the 4Motion Command Syntax