User Manual
Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 335 System Manual
4.3.10.15 Configuring the Service Flow Authorization Functionality
The Service Flow Authorization (SFA) functionality handles creation/
maintenance of pre-provisioned service flows for MS. It maps the AAA parameters
(service profile name) received from the AAA server to pre-configured
WiMAX-specific QoS parameters in the NPU. The SFA functionality enables you to
configure multiple service profiles with multiple service flows and classification
rules.
This section describes the commands to be used for:
“Configuring the SFA PHS Functionality” on page 335
“Displaying Configuration Information for the SFA PHS Functionality” on
page 336
“Configuring Service Profiles” on page 336
“Configuring Classification Rules” on page 355
4.3.10.15.1 Configuring the SFA PHS Functionality
To configure the SFA functionality with respect to PHS Rules, run the following
command:
To enable PHS: npu(config)# sfa phs-enable
To disable PHS: npu(config)# no sfa phs-enable
The default configuration is PHS Disable.
NOTE
You can display configuration information for the SFA functionality. For details, refer
Section 4.3.10.15.2.
For details on PHS Rules, refer to “Configuring PHS Rules” on page 386.
Command
Syntax
npu(config)# sfa phs-enable
npu(config)# no sfa phs-enable
Privilege
Level
10