User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 333 System Manual
4.3.10.14.5 Terminating the Service Group Configuration Mode
Run the following command to terminate the service group configuration mode:
npu(config-srvcgrp)# exit
4.3.10.14.6 Deleting a Service Group
You can, at any time, run the following command to delete a service group:
npu(config)# no srvc-grp <grp-alias>
Command
Modes
Service group-DHCP relay configuration mode
Command
Syntax
npu(config-srvcgrp)# exit
Privilege
Level
10
Command
Modes
Service group configuration mode
NOTE
A Service Group cannot be deleted if it is assigned to a Service Flow. For details refer to
“Configuring Service Flows” on page 339.
Command
Syntax
npu(config)# no srvc-grp <grp-alias>
Privilege
Level
10