User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 327 System Manual
4.3.10.14.4.3.2Restoring the Default Configuration Parameters for the DHCP Proxy
Run the following command to restore the default values of one or several DHCP
proxy parameters. This command can also be used to delete the configured DNS
server address (if specified).
npu(config-srvcgrp-dhcpproxy)# no [offerreuse-holdtime]
[lease-interval] [dnssrvr-addr][renew-interval] [rebind-interval]
Specify one or several parameters to restore the specified parameters to their
default values. Do not specify any parameter to restore all of these parameters to
their default values.
4.3.10.14.4.3.3Terminating the DHCP Proxy Configuration Mode
Run the following command to terminate the DHCP proxy configuration mode:
npu(config-srvcgrp-dhcpproxy)# exit
Command
Modes
Service group-DHCP proxy configuration mode
NOTE
Refer Section 4.3.10.14.4.3.1 for a description and default values of these parameters.
Command
Syntax
npu(config-srvcgrp-dhcpproxy)# no
[offerreuse-holdtime] [lease-interval]
[dnssrvr-addr][renew-interval] [rebind-interval]
Privilege
Level
10
Command
Modes
Service group-DHCP proxy configuration mode
Command
Syntax
npu(config-srvcgrp-dhcpproxy)# exit
Privilege
Level
10