User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 321 System Manual
4.3.10.14.4.2.3Configuring Exclude IP Addresses for the DHCP Server
Run the following command to configure exclude IP addresses for the DHCP
server:
npu(config-srvcgrp-dhcpserver)# exclude-addr <no. of Addrs (1-9)>
<ipv4addr> [<ipv4addr>] ….
In each command you may add up to 9 IP addresses to be excluded. The total
number of excluded IP addresses is up to a maximum of 16384.
Privilege
Level
10
Command
Modes
Service group-DHCP server configuration mode
IMPORTANT
An error may occur if you provide an invalid IP address. Refer the syntax description for more
information about the appropriate values and format for configuring this parameters.
Command
Syntax
npu(config-srvcgrp-dhcpserver)# exclude-addr <no. of Addrs (1-9)>
<ipv4addr> [<ipv4addr>] ….
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<no. of Addrs
(1-9)>
The number of IP addresses
to be excluded
Mandatory N/A 1-9
<ipv4addr> Denotes the exclude IP
address that will not be
assigned to an MS by the
DHCP server.
The number of IP address
entries must match the value
defined by the no. of Addrs
parameter.
Mandatory N/A Valid IP
address