User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 320 System Manual
4.3.10.14.4.2.2Restoring Configuration Parameters for the DHCP Server
Run the following command to restore the default values of one or several DHCP
server parameters. This command can be used to delete the DNS server address
configuration (if specified).
npu(config-srvcgrp-dhcpserver)# no [lease-interval]
[renew-interval] [rebind-interval] [dnssrvr-addr]
[offerreuse-holdtime]
Specify one or several parameters to restore the specified parameters to their
default values. Do not specify any parameter to restore all of these parameters to
their default values.
[opt43
{[Name
<string(64)>
]
Configures option 43 Name Optional Internet
Gateway
Device.
Manage
mentSer
ver.URL
String (up to 64
characters)
[Value
<string(64)>
]
Configures option 43 Value Optional empty
string
String (up to 64
characters)
[Sname
<string(64)>
]
Configures the server host
name. This parameter is sent
in dhcp-offer / dhcp-ack
messages and may be used
by certain CPEs.
Optional empty
string
String (up to 64
characters)
[File
<string(128)
>]
Configures the boot file
name. This parameter is sent
in dhcp-offer / dhcp-ack
messages and may be used
by certain CPEs.
Optional empty
string
String (up to
128 characters)
Command
Modes
Service Group-DCHP server configuration mode
NOTE
Refer to Section 4.3.10.14.4.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-srvcgrp-dhcpserver)# no
[lease-interval] [renew-interval]
[rebind-interval] [dnssrvr-addr] [offerreuse-holdtime]