User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 315 System Manual
4.3.10.14.3 Enabling/Disabling VLAN Service Interface
Run the following commands to enable/disable the creation of a data-path for a
VLAN Service:
To enable: npu(config-srvcgrp)# config {[serviceVlanEnable]}
To disable: npu(config-srvcgrp)# no serviceVlanEnable
[dhcp-ownaddr
<ipv4addr>]
Denotes the IPv4 address of
the DHCP server/ relay/
proxy.
For a service group using a
VLAN service interface,
should be in same subnet
with the Default Gateway
configured for the service
interface associated with the
service group. Subnet mask
is taken as the default subnet
mask i.e 255.255.255.0.
Note: In DHCP Server mode,
the DHCP server IP address
must be in the same subnet
but outside the range
allocated for users address
pool as provisioned in the
DHCP Server.
Mandatory N/A Valid IP
Address
{dhcp-server
|dhcp-proxy|
dhcp-relay}
Mode of IP address allocation
used for subscribers: DHCP
Server/ Proxy/ Relay.
Mandatory N/A
 dhcp-server
 dhcp-proxy
 dhcp-relay
{ServiceGrpIfA
ccounting
{enable|
disable}}
Denotes whether accounting
is enabled or disabled for the
service interface.
Optional Enable
 Enable
 Disable
{ServiceGrpI
fMsLoopBack
{enable|
disable}}
Denotes whether MS
loopback is enabled or
disabled for the service
interface
Optional Disable
 Enable
 Disable
Command
Modes
Service group configuration mode