User Manual
Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 312 System Manual
After enabling the service group configuration mode, you can execute any of the
following tasks:
Configure the common parameters for the service group (refer to
Section 4.3.10.14.2)
Enable the service group operation mode and configure the DHCP
server/proxy/relay-specific parameters (refer to Section 4.3.10.14.4.1)
After executing these tasks, you can terminate the service group configuration
mode (refer to Section 4.3.10.14.5).
NOTE
You can display configuration information for specific or all service groups. For details, refer to
Section 4.3.10.15.2.
Command
Syntax
npu(config)# srvc-grp <grp-alias> [ServiceGrpType {IP | VPWS-QinQ |
VPWS-Transparent}]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<grp-alias> Denotes the group-alias of
the service group for which
the service group
configuration mode is to be
enabled. If you want to create
a new service group, specify
the group alias to be assigned
to the srevice group.
Mandatory N/A String (1 to 15
characters)
[ServiceGrpT
ype {IP |
VPWS-QinQ |
VPWS-Transpa
rent} ]
The Service group’s type. Optional IP
IP
VPWS-QinQ
VPWS-Trans
parent