User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 309 System Manual
4.3.10.13.2.2 Restoring the Default Global RADIUS Configuration Parameters
To restore the default global RADIUS configuration used for AAA clients, run the
following command:
npu(config)# no radius [accessreq-retries] [accessreq-interval]
[nasid] [timezone-offset] [mtu]
[nasid
<nas-identifie
r>]
Denotes the unique identifier
of the ASNGW NAS. Sent in
Access Request message
only if configured. Should be
in FQDN format.
Optional null String (up to 64
characters)
[timezone-offs
et
<time-offset(0
-86400)>]
Denotes the time zone offset,
in seconds, from GMT at the
NAS.
Optional 0 0-86400
[mtu <framed
mtu
size(1020-2000
)>]
Denotes the MTU to be used
for the AAA client
functionality.
Optional 2000 1020-2000
[RadiusAtrbtTy
peServiceProfi
leName
<AtrbtTypeId(1
-255)>]
Denotes the RADIUS
attribute in which the
ASN-GW shall expect to get
the service profile name. For
example, configure 11 if AAA
uses Filter ID as the container
of service profile name,
Use only unassigned
freetext-type RADIUS
attributes.
Optional 11 1-255
Command
Modes
Global configuration mode
NOTE
Refer Section 4.3.10.13.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no radius
[accessreq-retries] [accessreq-interval] [nasid]
[timezone-offset] [mtu]