User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 304 System Manual
Command
Syntax
npu(config-aaa)# config [src-intf <ip-intf>] [primary-serveraddr
<ipv4addr>] [alternate-serveraddr <ipv4addr>] [rad-sharedsecret <string>]
[auth-port <port>] [acct-port <port>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[src-intf
<ip-intf>]
Indicates the IP address of
the interface providing
RADIUS client functionality.
Must be the IP address of the
Bearer interface.
Note: If you are modifying the
service interface for the AAA
client, save the current
configuration (refer
Section 4.3.4.1) and reset
the NPU (
Section 4.2.2.1)
for the change to take effect.
Mandatory N/A IP address of
bearer
interface
[primary-serve
raddr
<ipv4addr>]
Denotes IPv4 address of the
primary AAA server. It is
mandatory to specify a value
for this parameter if you do
not configure an alternate
server.
Optional 0.0.0.0 Valid IP
Address
[alternate-ser
veraddr
<ipv4addr>]
Denotes IPv4 address of the
alternate AAA server.
It is mandatory to specify a
value for this parameter if you
do not configure a primary
server.
Optional N/A Valid IP
Address
[rad-sharedsec
ret <string>]
Denotes the shared secret
between the AAA client and
the AAA server.
Mandatory N/A String (1 to 49
characters)
[auth-port
<port>]
Denotes the Authenticator
port on which the AAA client
listens to and sends RADIUS
authentication messages.
Optional 1812 0-65535