User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 303 System Manual
4.3.10.13.1.2 Configuring Parameters for the AAA Client
After enabling the AAA client configuration mode, run the following command to
configure the parameters for the AAA client:
npu(config-aaa)# config [src-intf <ip-intf>] [primary-serveraddr
<ipv4addr>] [alternate-serveraddr <ipv4addr>] [rad-sharedsecret
<string>] [auth-port <port>] [acct-port <port>]
Command
Syntax
npu(config)# aaa-client <client-alias>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<client-alias> Denotes the client-alias of the
AAA client for which the
configuration mode is to be
enabled.
If you want to create a new
AAA client, specify the
client-alias for the AAA client
that you want to create.
Mandatory N/A String
Command
Modes
Global configuration mode
NOTE
You can display configuration information for a specific or all AAA clients. For details, refer to
Section 4.3.10.13.1.6.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.