User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 301 System Manual
4.3.10.13 Configuring the AAA Client Functionality
The AAA client functionality enables configuration of one RADIUS client. The
RADIUS client encapsulates the messages destined for the AAA server in RADIUS
messages or decapsulates messages sent by the AAA server for the MS.
The RADIUS client can be assigned an independent self address, primary AAA
server address, alternate AAA server address, shared secret, and protocol port.
In addition, you can also configure certain RADIUS parameters such as the NAS
ID and the time zone offset that are applicable for all AAA clients.
This section describes the commands for:
 “Managing AAA Client Configuration” on page 301
 “Managing Global RADIUS Configuration Parameters” on page 307
4.3.10.13.1 Managing AAA Client Configuration
1 Enable the AAA client configuration mode (refer to Section 4.3.10.13.1.1)
Display
Format
VLAN
Service
Interface
% Asn-gateway Srvc Intf config
Srvcif-Alias <string>
SrvcifDescr <string>
intf-type VLAN
SrvcifVlanId <vlan id>
SrvcifDfltGwIpAddr <IP address>
TunIPIPMTU <size>
Display
Format
QinQ
Service
Interface
% Asn-gateway Srvc Intf config
Srvcif-Alias <string>
SrvcifDescr <string>
intf-type QinQ
Q-in-Q SrvcifVlanId <vlan id>
Command
Modes
Global command mode
To configure one or more AAA clients: