User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 299 System Manual
4.3.10.12.4.3 Terminating the QinQ Service Interface Configuration Mode
Run the following command to terminate the QinQ service interface configuration
mode:
npu(config-srvcif-QinQ)# exit
4.3.10.12.5 Deleting a Service Interface
You can, at any time, run the following command to delete service interface:
npu(config)# no srvc-intf [<intf-alias>]
Command
Syntax
npu(config-srvcif-QinQ)# exit
Privilege
Level
10
Command
Modes
QinQ Service interface configuration mode
NOTE
A Service Interface cannot be deleted if it is assigned to any Service Group.
A QinQ Service Interface cannot be deleted if it is assigned to a Service Flow (with a VPWS-QinQ
Service Group). For details refer to “Configuring Service Flows” on page 339.
Command
Syntax
npu(config)# no srvc-intf [
intf-alias>]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[intf-alias>
]
The alias of the Service
interface which needs to be
deleted
Mandatory N/A String