User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 293 System Manual
4.3.10.12.2.1 Configuring Parameter for IP-IP Service Interface
After enabling the IP-IP Service Interface configuration mode, run the following
command to configure the IP-IP service interface parameters:
This command shall configure one or more parameters of the IP-IP Service
Interface.
npu(config-srvcif-ipip)# config ([descr <string>] [tun-srcaddr <ip4addr>]
{tun-dstaddr <ipv4addr>} [tun-mtu <size(556-1804)>] [tun-chksm])
Command
Syntax
npu(config-srvcif-ip-ip)# config ([descr <string>] [tun-srcaddr <ip4addr>]
{tun-dstaddr <ipv4addr>} [tun-mtu <size(556-1804)>] [tun-chksm])
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
config ([descr
<string>]
A description of the Service
Interface.
Optional null String (up to 70
characters)
[tun-srcaddr
<ip4addr>]
The source IP address that
indicates the point of
origination of the tunnel for
the service interface.
Must be the same as the
Bearer IP Address.
Optional 0.0.0.0 Valid IP
Address.