User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 290 System Manual
4.3.10.12 Managing Service Interfaces
A Service Interface defines the parameters of the interface used by the NPU on the
network side for services using the applicable Service Interface.
Up to 10 Service Interfaces may be defined.
1 Enable the Service Interface configuration mode for the selected Service
Interface (refer to Section 4.3.10.12.1)
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[<qos-alias>] Denotes the QoS alias of the
bearer QoS marking rule that
you want to display.
Specify a value for this
parameter if you want to
display a specific bearer QoS
marking rule. Do not specify a
value for this parameter if you
want to display all bearer QoS
marking rules.
Optional N/A String
Display
Format
Bearer QoS Configuration :
qos-alias intf-type srvc-type trfc-priority media-type inner-dscp
outer-dscp vlan-priority status
voip <value> <value> <value> <value> <value> <value> enabled
Command
Modes
Global command mode
To configure a Service Interface: