User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 277 System Manual
4.3.10.9.2 Restoring the Default Configuration Parameters for the MS State
Change Functionality
To restore the default configuration for the MS State Change functionality, run the
following command:
npu(config)# no msscfn [msscrsp-retries] [msscrsp-interval]
[sbc-holdtime] [reg-holdtime] [msscdrctv-retries]
[msscdrctv-interval]
[sbc-holdtime
<timeout>]
Denotes the period, in
milliseconds, within which the
basic capabilities negotiation
procedure should be
completed. At the end of this
period, the NPU starts the
authentication/ registration
procedure for the MS,
depending on accepted
authentication policy.
Optional 5 0-100
[reg-holdtime
<timeout>]
Denotes the interval, in
seconds, for the MS
registration procedure
timeout. After this interval, the
NPU changes the MS state to
the registered state, and
initiates the data path creation
procedure (for authenticated
MSs).
Optional 5 0-100
[msscdrctv-ret
ries
<retransmissio
ns>]
Denotes the maximum
number of times, the NPU
may retransmit the MS state
change directive.
Optional 3 0-5
[msscdrctv-int
erval
<timeout>
Denotes the period, in
milliseconds, for which the
NPU waits for an
acknowledgement for the MS
state change directive. If the
NPU does not receive an
acknowledegment within this
period, it retransmits the state
change directive.
Optional 10 0-500
Command
Modes
Global configuration mode