User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 276 System Manual
4.3.10.9.1 Configuring Parameters for the MS State Change Functionality
To configure the parameters for the MS State Change functionality, run the
following command:
npu(config)# msscfn [msscrsp-retries <retransmissions>]
[msscrsp-interval <timeout>] [sbc-holdtime <timeout>] [reg-holdtime
<timeout>] [msscdrctv-retries <retransmissions>]
[msscdrctv-interval <timeout>]
NOTE
You can display configuration information for the MS state change functionality. For details, refer to
Section 4.3.10.9.3.
IMPORTANT
An error may occur if you provide an invalid value for any of these parameters. Refer the syntax
description for more information about the appropriate values and format for configuring these
parameters.
Command
Syntax
npu(config)# msscfn [msscrsp-retries <retransmissions>] [msscrsp-interval
<timeout>] [sbc-holdtime <timeout>] [reg-holdtime <timeout>]
[msscdrctv-retries <retransmissions>] [msscdrctv-interval <timeout>]
Privilege
Level
15
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[msscrsp-retri
es
<retransmissio
ns>]
Denotes the maximum
number of times, the NPU
retransmits the MS state
change response.
Optional 3 1-5
[msscrsp-inter
val <timeout>]
Denotes the period, in
milliseconds for which the
NPU waits for an
acknowledgement for the MS
state change response. If the
NPU does not receive an
acknowledgement within this
period, it retransmits the MS
state change response.
Optional 10 5- 500