User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 271 System Manual
4.3.10.7.2 Restoring the Default Parameters for the Data Path Function
To restore the default configuration for the data path function, run the following
command:
npu(config)# no datapath [initpathregreq-retries]
[initpathregreq-interval] [msderegreq-retries]
[msderegreq-interval] [pathregreq-retries] [pathregreq-interval]
[pathregrsp-retries] [pathregrsp-interval] [pathregstart-interval]
[mipwaitdhcp-holdtime]
[pathregstart-
interval
<timeout>]
Indicates the period, in
milliseconds, within which the
path registration procedure is
initiated, after the path
pre-registration procedure is
complete. If the path
registration procedure is not
completed within the period
specified by this parameter,
the MS is de-registered.
Optional 1000 5- 2000
[mipwaitdhcp-h
oldtime
<timeout>]
Denotes the period, in
seconds, for allocating the IP
address, after the path
registration procedure is
complete.
Optional 0 0 - 120
Command
Modes
Global configuration mode
NOTE
Refer to Section 4.3.10.7.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no datapath
[initpathregreq-retries]
[initpathregreq-interval] [msderegreq-retries] [msderegreq-interval]
[pathregreq-retries] [pathregreq-interval] [pathregrsp-retries]
[pathregrsp-interval] [pathregstart-interval] [mipwaitdhcp-holdtime]
Privilege
Level
15