User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 261 System Manual
4.3.10.4.3 Displaying Configuration Information for the PMIP Client Functionality
To display PMIP client configuration information, run the following command:
npu# show mip-client
4.3.10.5 Configuring the ASN Interface
The ASN interface is the NPU interface that is exposed towards the BS or another
ASN gateway. You can configure ASN interface-specific information, such as the
IP address to be used for the NPU to communicate with the BS and other ASN
gateways.
This section describes the commands to be used for:
 “Assigning a Pre-configured IP Interface” on page 261
 “Displaying Configuration Information for the ASN Interface” on page 263
4.3.10.5.1 Assigning a Pre-configured IP Interface
To assign a pre-configured IP interface to the ASN side, that is, the R4/R6
interface, run the following command:
npu(config)# asnif <ip-intf>
Command
Syntax
npu# show mip-client
Privilege
Level
1
Display
Format
PMIP-Client Configuration :
mslifetime = <value>
mslifetime-guard = <value>
registration-retries = <value>
registration-interval = <value>
Command
Modes
Global command mode