User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 260 System Manual
4.3.10.4.2 Restoring the Default Configuration Parameters for the PMIP Client
Functionality
To restore the default configuration for the PMIP client functionality, run the
following command:
npu(config)# no mip-client [mslifetime] [mslifetime-guard]
[registration-retries] [registration-interval]
[mslifetime-gu
ard <percent>]
Denotes the period for which
the PMIP remains active. The
value of this parameter
should be a percentage of the
mslifetime parameter. At
the end of this period, the
PMIP attempts
re-registration.
Optional 65% 0-100
[registration-
retries
<retransmissio
ns>]
Denotes the maximum
number of registration
requests that can be sent by
the NPU.
Optional 3 0-5
[registration-
interval
<timeout>]
Denotes the interval between
successive requests of an
MS, in seconds, within which
the MIP registration response
should be sent by the HA.
Optional 10 5-100
Command
Modes
Global configuration mode
NOTE
Refer to Section 4.3.10.4.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no mip-client
[mslifetime] [mslifetime-guard]
[registration-retries] [registration-interval]
Privilege
Level
15
Command
Modes
Global configuration mode