User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 257 System Manual
4.3.10.3.2 Restoring the Default Configuration Parameters for the MIP-FA
Functionality
To restore the default configuration for the MIP-FA functionality, run the following
command:
npu(config)# no mip-fa [allowed-mslifetime] [agent-advertisements]
[advertisement-interval]
Command
Syntax
npu(config)# mip-fa [allowed-mslifetime <timeout>] [agent-advertisements
<no of agent advertisement>] [advertisement-interval <timeout>]
Privilege
Level
15
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[allowed-mslif
etime
<timeout>]
Denotes the maximum
period, in seconds, for which
the IP address allocated to
the MS is active.
Optional 9000 0-9000
[agent-adverti
sements <no of
agent
advertisement>
]
Denotes the maximum
number of initial agent
advertisements sent to the
MS.
Optional 3 0-5
[advertisement
-interval
<timeout>]
Denotes the interval, in
seconds, between successive
agent advertisements.
Optional 10 5-100
Command
Modes
Global configuration mode
NOTE
Refer to Section 4.3.10.3.1 for a description and default values of these parameters.
Command
Syntax
npu(config)# no mip-fa
[allowed-mslifetime] [agent-advertisements]
[advertisement-interval]