User Manual

Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 256 System Manual
4.3.10.3 Configuring the MIP-Foreign Agent Functionality
When the MS is MIP-enabled, the NPU serves as the Foreign Agent (FA) for
transferring mobile IP messages between the MS and the HA. As the FA, the NPU
is responsible for registering the MS in the network. It provides security by using
the security associations (MIP keys) between the MS and FA, and FA and HA.
This section describes the commands to be used for:
 “Configuring Parameters for the MIP-FA Functionality” on page 256
 “Restoring the Default Configuration Parameters for the MIP-FA Functionality”
on page 257
 “Displaying Configuration Information for the MIP-FA Functionality” on
page 258
4.3.10.3.1 Configuring Parameters for the MIP-FA Functionality
To configure MIP-FA parameters, run the following command:
npu(config)# mip-fa [allowed-mslifetime <timeout>]
[agent-advertisements <no of agent advertisement>]
[advertisement-interval <timeout>]
Display
Format
IGMP Membership :
GrpMulticast-addr Src-addrlist
<value> <value> <value> ….
Command
Modes
Global configuration mode
IMPORTANT
The MIP-Foreign Agent functionality is not supported in the current release.
NOTE
You can display configuration information for the MIP-FA functionality. For details, refer to
Section 4.3.10.3.3.