User Manual
Chapter 4 - Operation and Administration Using the CLI NPU Configuration
4Motion 249 System Manual
4.3.10.1 Configuring the Next-hop IP Address-Network ID Mapping
The NPU maintains the mapping of the BS network ID to the next-hop IP address.
The next-hop IP address can be the IP address of an intermediate ASN-GW or the
destination BS. Using this mapping, the NPU resolves the BS-ID to IP address.
This section describes the commands to be used for:
“Configuring the Next-hop IP Address” on page 250
“Displaying the Next-hop IP Address-Network ID Mapping” on page 251
“Displaying the Next-hop IP Address-Network ID Mapping” on page 251
“Configuring the
Connectivity Service
Network Interface” on
page 279
Yes Yes
“Configuring Bearer Plane
QoS Marking Rules” on
page 281
Yes Yes
“Managing Service
Interfaces” on page 290
Yes Yes
“Configuring the AAA
Client Functionality” on
page 301
Yes Yes
“Managing Service
Groups” on page 310
Yes Yes
“Configuring the Service
Flow Authorization
Functionality” on
page 335
Yes
(Configure only DHCP Proxy for
a service group)
Yes
(Configure DHCP server, proxy
or relay for a service group)
“Configuring PHS Rules”
on page 386
Yes Yes
“Managing the ASN-GW
Keep-Alive Functionality”
on page 391
Yes Yes
Table 4-20: Tasks to be Executed for Configuring the ASN-GW Functionality
Task Required for Operating the
NPU with HA Support
Required for Operating the
NPU without HA Support