User Manual

Chapter 3 - Commissioning Completing the Site Configuration Using AlvariSTAR
4Motion 110 System Manual
e Uplink Data Zone Number of Sub-Channels (Air Frame Structure Zones
Tab):
◊ For a Bandwidth of 7 or 10 MHz, configure this parameter to the default
value of 35.
◊ For a Bandwidth of 5 MHz, configure this parameter to the default
value of 17.
4 Click Apply for the device to accept the configuration.
3.2.6.2.2 Advanced Screen
All the parameters in the Advanced screen should be left with their default values.
However, the Apply button must be clicked once (in any tab) for the device to
accept the default configuration.
3.2.6.3 Connectivity
3.2.6.3.1 Basic Screen - Bearer Tab
1 Configure the following mandatory parameters:
» IP Address
» IP Subnet Musk
» Default Gateway
2 Click Apply for the device to accept the configuration.
3.2.6.3.2 Basic Screen - Authentication Tab
1 Configure the mandatory Default Authenticator IP Address parameter.
2 Click Apply for the device to accept the configuration.
3.2.6.3.3 Advanced Screen
All the parameters in the Advanced page should be left with their default values.
However, the Apply button must be clicked for the device to accept the default
configuration.
3.2.7 Site Sector Configuration
1 Right click on the Site Sector level entry in the Navigation Pane. The New Site
Sector definition window will open.
To create a new Site Sector entity: