User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 576 System Manual
4.8.6.5.7 Displaying Configuration Information for Power Control Closed Loop -
MS in Network Entry Correction Policy Parameters
To display configuration for the Power Control Closed Loop - MS in Network Entry
Correction Policy parameters, run the following command:
npu# show pwrctrl-clne bs [<(1 to 16777215 StepSize 1)
Specify the BS ID if you want to display configuration for a particular BS. For
example, to display the Power Control Closed Loop - MS in Network Entry
parameters of BS 66053, run the following command:
Command
Syntax
npu# show pwrctrl-clunstable bs [<(1 to 16777215 StepSize 1)
Privilege
Level
1
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
<(1 to 16777215
StepSize 1)>
The BS ID
Specify a value for this
parameter if you want to
display the Closed Loop -
Unstable MS parameters of a
specific BS. Do not specify a
value for this parameter if you
want to display the Closed
Loop - Unstable MS
parameters of all BSs.
Optional N/A 1-16777215
Display
Format
(for each
existing BS
if requested
for all BSs)
BSIDLSB :<value>
ClosedLoopUnstableMSPositiveCorrectionCoefficient :<value>
ClosedLoopUnstableMSNegativeCorrectionCoefficient :<value>
ClosedLoopUnstableMSMaximumPositivePowerCorrection(dB):<value>
ClosedLoopUnstableMSMaximumNegativePowerCorrection(dB):<value>
Command
Modes
Global command mode