User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 568 System Manual
4.8.6.4 Terminating the Power Control Configuration Mode
Run the following command to terminate the Power Control configuration mode:
npu(config-bs-66053-pwrctrl)# exit
4.8.6.5 Displaying Configuration Information for Power Control
Parameters
You can display the current configuration information for the following
parameters tables:
 Noise and Interference Level (refer to Section 4.8.6.5.1)
 Maximum EIRP (refer to Section 4.8.6.5.2)
 Required C/N Level (refer to Section 4.8.6.5.3)
 Open Loop Correction Policy (refer to Section 4.8.6.5.4)
 Open Loop Correction Range (refer to Section 4.8.6.5.5)
 Closed Loop - Unstable MS (refer to Section 4.8.6.5.6)
 Closed Loop - MS in Network Entry (refer to Section 4.8.6.5.7)
 Closed Loop Correction Range (refer to Section 4.8.6.5.8)
 All (refer to Section 4.8.6.5.9)
IMPORTANT
Do not forget to execute the apply command before terminating the Power Control configuration
mode: npu(config-bs-66053-pwrctrl)# apply
Command
Syntax
npu(config-bs-66053-pwrctrl)# exit
Privilege
Level
10
Command
Modes
bs power control configuration mode