User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 567 System Manual
4.8.6.3.8 Restoring the Default Values of Power Control Closed Loop Correction
Range Parameters
To restore some or all of the Closed Loop Correction Range parameters to their
default values, run the following command:
npu(config-bs-66053-pwrctrl)# no clrange [lowthrshld-linear]
[lowthrshld-constant] [highthrshld-linear] [highthrshld-constant]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the highthrshld-linear and
highthrshld-constant parameters to the default values, run the following
command:
npu(config-bs-66053-pwrctrl)# no clrange highthrshld-linear
highthrshld-constant
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
To restore all Closed Loop Correction Range parameters to their default value, run
the following command:
npu(config-bs-66053-pwrctrl)# no clrange
Privilege
Level
10
Command
Modes
bs power control configuration mode
NOTE
Refer to Section 4.8.6.2.8 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-pwrctrl)# no clrange [lowthrshld-linear ]
[lowthrshld-constant ] [highthrshld-linear ]
[highthrshld-constant ]
Privilege
Level
10
Command
Modes
bs power control configuration mode