User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 566 System Manual
4.8.6.3.7 Restoring the Default Values of Power Control Closed Loop - MS in
Network Entry Correction Policy Parameters
To restore some or all of the Open Loop - MS in Network Entry Correction Policy
parameters to their default values, run the following command:
npu(config-bs-66053-pwrctrl)# no clne [positivecoefficient] [negativecoefficient]
[max-positivecorrection] [max-negativecorrection]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the positivecoefficient and
negativecoefficient parameters to the default values, run the following command:
npu(config-bs-66053-pwrctrl)# no clne positivecoefficient
negativecoefficient
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
To restore all Open Loop - MS in Network Entry parameters to their default value,
run the following command:
npu(config-bs-66053-pwrctrl)# no clne
Command
Syntax
npu(config-bs-66053-pwrctrl)# no clunstable [positivecoefficient ]
[negativecoefficient ] [max-positivecorrection ]
[max-negativecorrection ]
Privilege
Level
10
Command
Modes
bs power control configuration mode
NOTE
Refer to Section 4.8.6.2.7 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-pwrctrl)# no clne [positivecoefficient ]
[negativecoefficient ] [max-positivecorrection ]
[max-negativecorrection ]