User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 564 System Manual
npu(config-bs-66053-pwrctrl)# no olpolicy positivecoefficient
negativecoefficient
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
To restore all Open Loop Correction Policy parameters to their default value, run
the following command:
npu(config-bs-66053-pwrctrl)# no olpolicy
4.8.6.3.5 Restoring the Default Values of Power Control Open Loop Correction
Range Parameters
To restore some or all of the Open Loop Correction Range parameters to their
default values, run the following command:
npu(config-bs-66053-pwrctrl)# no olrange [lowthrshld-linear]
[lowthrshld-constant] [highthrshld-linear] [highthrshld-constant]
You can restore only some parameters to their default values by specifying only
those parameters. For example, to restore only the highthrshld-linear and
highthrshld-constant parameters to the default values, run the following
command:
npu(config-bs-66053-pwrctrl)# no olrange highthrshld-linear
highthrshld-constant
These parameters will be restored to their default value, while the other
parameters will remain unchanged.
NOTE
Refer to Section 4.8.6.2.4 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-pwrctrl)# no olpolicy [positivecoefficient ]
[negativecoefficient ] [max-positivecorrection ]
[max-negativecorrection ]
Privilege
Level
10
Command
Modes
bs power control configuration mode