User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 562 System Manual
4.8.6.3.2 Restoring the Default Values of the Power Control Maximum EIRP
Parameter
To restore the maxeirxp parameter to its default value, run the following
command:
npu(config-bs-66053-pwrctrl)# no maxeirxp
4.8.6.3.3 Restoring the Default Values of Power Control Required C/N Level
Parameters
To restore some or all of the Required C/N Levels parameters to their default
values, run the following command:
NOTE
Refer to Section 4.8.6.2.1 for a description and default values of these parameters.
Command
Syntax
npu(config-bs-66053-pwrctrl)# no nilevels [cqi-ack-ranging ]
[pusc]
Privilege
Level
10
Command
Modes
bs power control configuration mode
NOTE
Refer to Section 4.8.6.2.2 for a description and default value of this parameter.
Command
Syntax
npu(config-bs-66053-pwrctrl)# no maxeirxp
Privilege
Level
10
Command
Modes
bs power control configuration mode