User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 561 System Manual
4.8.6.3 Restoring Default Values for Power Control Configuration
Parameters
After enabling the Power Control configuration mode you can restore the default
values for parameters in the following parameters tables:
 Noise and Interference Level (refer to Section 4.8.6.3.1)
 Maximum EIRP (refer to Section 4.8.6.3.2)
 Required C/N Level (refer to Section 4.8.6.3.3)
 Open Loop Correction Policy (refer to Section 4.8.6.3.4)
 Open Loop Correction Range (refer to Section 4.8.6.3.5)
 Closed Loop - Unstable MS (refer to Section 4.8.6.3.6)
 Closed Loop - MS in Network Entry (refer to Section 4.8.6.3.7)
 Closed Loop Correction Range (refer to Section 4.8.6.3.8)
4.8.6.3.1 Restoring the Default Values of Power Control Target Noise and
Interference Level Parameters
To restore one or all of the Target Noise and Interference Level parameters to their
default values, run the following command:
npu(config-bs-66053-pwrctrl)# no nilevels [cqi-ack-ranging] [pusc]
You can restore only one parameter to its default values by specifying only that
parameter. For example, to restore only the pusc to the default value, run the
following command:
npu(config-bs-66053-pwrctrl)# no nilevels pusc
The parameter will be restored to its default value, while the other parameter will
remain unchanged.
To restore all Target Noise and Interference Level parameters to their default
value, run the following command:
npu(config-bs-66053-pwrctrl)# no nilevels
Command
Modes
bs power control configuration mode