User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 560 System Manual
npu(config-bs-66053-pwrctrl)# clrange [lowthrshld-linear <(-20 to 0 StepSize
0.1)>] [lowthrshld-constant <(-20 to 0 StepSize 0.1)>] [highthrshld-linear <(0 to 20
StepSize 0.1)>] [highthrshld-constant <(0 to 20 StepSize 0.1)>]
IMPORTANT
When creating a new BS, at least one of the Power Control Closed Loop Correction Range
parameters must be configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-pwrctrl)# clrange [lowthrshld-linear <(-20 to
0 StepSize 0.1)> ] [lowthrshld-constant <(-20 to 0 StepSize 0.1)>
] [highthrshld-linear <(0 to 20 StepSize 0.1)> ]
[highthrshld-constant <(0 to 20 StepSize 0.1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[lowthrshld-linear
<(-20 to 0 StepSize
0.1)> ]
Closed loop correction range
threshold (in dB) below which
linear corrections are made.
Cannot be lower than
clrange-lowthrshld-constant
(see below)
Optional -2 -20 to 0 in
steps of 0.1
lowthrshld-constan
t <(-20 to 0
StepSize 0.1)> ]
Closed loop correction range
threshold (in dB) below which
constant corrections are
made.
Optional -8 -20 to 0 in
steps of 0.1
[highthrshld-linear
<(0 to 20 StepSize
0.1)> ]
Closed loop correction range
threshold (in dB) above which
linear corrections are made.
Optional 2 -20 to 0 in
steps of 0.1
[highthrshld-consta
nt <(0 to 20
StepSize 0.1)> ]
Closed loop correction range
threshold (in dB) above which
constant corrections are
made.
Cannot be lower than
clrange-highthrshld-linear
(see above)
Optional 8 -20 to 0 in
steps of 0.1