User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 559 System Manual
4.8.6.2.8 Configuring the Power Control Closed Loop Correction Range
Parameters
To configure the Closed Loop Correction Range parameters, run the following
command:
IMPORTANT
When creating a new BS, at least one of the Power Control Closed Loop - MS in Network Entry
parameters must be configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-pwrctrl)# clne [positivecoefficient <(0 to 1
StepSize 0.05)> ] [negativecoefficient <(0 to 1 StepSize 0.05)> ]
[max-positivecorrection <(0 to 20 StepSize 0.1)> ]
[max-negativecorrection <(0 to 20 StepSize 0.1)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[positivecoefficient
<(0 to 1 StepSize
0.05)> ]
Correction coefficient for
network entry in closed loop
when giving positive
corrections
Optional 0.7 0 to 1 dB in
steps of 0.05
[negativecoefficien
t <(0 to 1 StepSize
0.05)> ]
Correction coefficient for
network entry in closed loop
when giving negative
corrections
Optional 0.7 0 to 1 dB in
steps of 0.05
[max-positivecorre
ction <(0 to 20
StepSize 0.1)> ]
Maximum positive power
correction (in dB) for network
entry in closed loop
Optional 8 0 to 20 in steps
of 0.1
[max-negativecorr
ection <(0 to 20
StepSize 0.1)> ]
Maximum negative power
correction (in dB) for network
entry in closed loop
Optional 8 0 to 20 in steps
of 0.1
Command
Modes
bs power control configuration mode