User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 557 System Manual
4.8.6.2.6 Configuring the Power Control Closed Loop - Unstable MS Correction
Policy Parameters
To configure the Closed Loop - Unstable MS Correction Policy parameters, run the
following command:
npu(config-bs-66053-pwrctrl)# clunstable [positivecoefficient <(0 to 1 StepSize
0.05)>] [negativecoefficient <(0 to 1 StepSize 0.05)>] [max-positivecorrection <(0 to
20 StepSize 0.1)>][max-negativecorrection <(0 to 20 StepSize 0.1)>]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[lowthrshld-linear
<(-20 to 0 StepSize
0.1)> ]
The open loop correction
range threshold (in dB) below
which linear corrections are
made.
Cannot be lower than
olrange-lowthrshld-constant
(see below)
Optional -18 -20 to 0 in
steps of 0.1
[lowthrshld-consta
nt <(-20 to 0
StepSize 0.1)> ]
The open loop correction
range threshold (in dB) below
which constant corrections
are made.
Optional -19 -20 to 0 in
steps of 0.1
[highthrshld-linear
<(0 to 20 StepSize
0.1)> ]
The open loop correction
range threshold (in dB) above
which linear corrections are
made.
Optional 18 0 to 20 in steps
of 0.1
[highthrshld-consta
nt <(0 to 20
StepSize 0.1)> ]
The open loop correction
range threshold (in dB) above
which constant corrections
are made.
Cannot be lower than
olrange-highthrshld-linear
(see above)
Optional 19 0 to 20 in steps
of 0.1
Command
Modes
bs power control configuration mode
IMPORTANT
When creating a new BS, at least one of the Power Control Closed Loop - Unstable MS parameters
must be configured explicitly (even if configured to the default value).