User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 556 System Manual
4.8.6.2.5 Configuring the Power Control Open Loop Correction Range
Parameters
To configure the Open Loop Correction Range parameters, run the following
command:
npu(config-bs-66053-pwrctrl)# olrange [lowthrshld-linear <(-20 to 0 StepSize
0.1)>] [lowthrshld-constant <(-20 to 0 StepSize 0.1)>] [highthrshld-linear <(0 to 20
StepSize 0.1)>] [highthrshld-constant <(0 to 20 StepSize 0.1)>]
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[positivecoefficient
<(0 to 1 StepSize
0.05)> ]
Correction coefficient for
open loop when giving
positive corrections
Optional 0.7 0 to 1 in steps
of 0.05
[negativecoefficien
t <(0 to 1 StepSize
0.05)> ]
Correction coefficient for
open loop when giving
negative corrections
Optional 0.7 0 to 1 in steps
of 0.05
[max-positivecorre
ction <(0 to 20
StepSize 0.1)> ]
Maximum positive power
correction (in dB) for open
loop
Optional 8 0 to 20 in steps
of 0.1
[max-negativecorr
ection <(0 to 20
StepSize 0.1)> ]
Maximum negative power
correction (in dB) for open
loop
Optional 8 0 to 20 in steps
of 0.1
Command
Modes
bs power control configuration mode
IMPORTANT
When creating a new BS, at least one of the Power Control Open Loop Correction Range
parameters must be configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-pwrctrl)# olrange [lowthrshld-linear <(-20 to
0 StepSize 0.1)> ] [lowthrshld-constant <(-20 to 0 StepSize 0.1)>
] [highthrshld-linear <(0 to 20 StepSize 0.1)> ]
[highthrshld-constant <(0 to 20 StepSize 0.1)> ]
Privilege
Level
10