User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 555 System Manual
4.8.6.2.4 Configuring the Power Control Open Loop Correction Policy
Parameters
To configure the Open Loop Correction Policy parameters, run the following
command:
npu(config-bs-66053-pwrctrl)# olpolicy [positivecoefficient <(0 to 1 StepSize
0.05)>] [negativecoefficient<(0 to 1 StepSize 0.05)>] [max-positivecorrection <(0 to
20 StepSize 0.1)>] [max-negativecorrection <(0 to 20 StepSize 0.1)>]
[qam64-3by4 <(-20
to 50 StepSize 1)> ]
The C/N in dB required for
transmitting using 64QAM 3/4,
reported to the MS for power
control purposes.
Must be in the range from
requiredcnr-qam64-2by3 - 8 to
requiredcnr-qam54-2by3 + 7 (see
qam54-2by3 parameter above)
Optional 23 -20 to 50
[qam64-5by6 <(-20
to 50 StepSize 1)> ]
he C/N in dB required for
transmitting using 64QAM 5/6,
reported to the MS for power
control purposes.
Must be in the range from
requiredcnr-qam64-3by4 - 8 to
requiredcnr-qam64-3by4 + 7 (see
qam64-3by4 parameter above)
Optional 23 -20 to 50
Command
Modes
bs power control configuration mode
IMPORTANT
When creating a new BS, at least one of the Power Control Open Loop Correction Policy
parameters must be configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-pwrctrl)# olpolicy [positivecoefficient <(0 to
1 StepSize 0.05)> ] [negativecoefficient<(0 to 1 StepSize 0.05)> ]
[max-positivecorrection <(0 to 20 StepSize 0.1)> ]
[max-negativecorrection <(0 to 20 StepSize 0.1)> ]
Privilege
Level
10