User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 552 System Manual
4.8.6.2.3 Configuring the Power Control Required C/N Level Parameters
The Required C/N Levels table enables defining the Carrier to Noise Ratios
required for various types of transmissions.
To configure the Required C/N Levels, run the following command:
npu(config-bs-66053-pwrctrl)# requiredcnr [ack <(-20 to 50 StepSize 1)>] [cqi
<(-20 to 50 StepSize 1)>] [cdma <(-20 to 50 StepSize 1)>] [qpsk-1by2 <(-20 to 50
StepSize 1)>] [qpsk-3by4 <(-20 to 50 StepSize 1)>] [qam16-1by2 <(-20 to 50
StepSize 1)>] [qam16-3by4 <(-20 to 50 StepSize 1)>] [qam64-1by2 <(-20 to 50
StepSize 1)>] [qam64-2by3 <(-20 to 50 StepSize 1)>] [qam64-3by4 <(-20 to 50
StepSize 1)>] [qam64-5by6 <(-20 to 50 StepSize 1)>]
Command
Syntax
npu(config-bs-66053-pwrctrl)# maxeirxp <(-140 to -40 StepSize 1)>
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
maxeirxp <(-140 to
-40 StepSize 1)>
The maximum effective
isotropic received power at
the BS for Initial ranging, in
dBm.
Optional -124 -140 to -40
Command
Modes
bs power control configuration mode
IMPORTANT
When creating a new BS, at least one of the Power Control Required C/N Level parameters must
be configured explicitly (even if configured to the default value).