User Manual

Chapter 4 - Operation and Administration Using the CLI Managing BSs
4Motion 551 System Manual
4.8.6.2.2 Configuring the Power Control Maximum EIRP
The maxeirxp parameter enables defining the maximum effective isotropic
received power at the BS for Initial ranging.
To configure the maxeirxp, run the following command:
npu(config-bs-66053-pwrctrl)# maxeirxp <(-140 to -40 StepSize 1)>
IMPORTANT
When creating a new BS, at least one of the Power Control Target Noise and Interference Level
parameters must be configured explicitly (even if configured to the default value).
Command
Syntax
npu(config-bs-66053-pwrctrl)# nilevels [cqi-ack-ranging <(-150 to
-22.5 StepSize 0.5)> ] [pusc <(-150 to -22.5 StepSize 0.5)> ]
Privilege
Level
10
Syntax
Description
Parameter Description Presence Default
Value
Possible
Values
[cqi-ack-ran
ging <(-150
to -22.5
StepSize
0.5)> ]>
Target Noise and interference
level for the CQI, ACK and
periodic ranging regions, in
dBm.
Optional -128 -150 to -22.5 in
steps of 0.5
[pusc <(-150
to -22.5
StepSize
0.5)> ]
Target Noise and interference
level for the PUSC zone, in
dBm
Optional -128 -150 to -22.5 in
steps of 0.5
Command
Modes
bs power control configuration mode
IMPORTANT
When creating a new BS, the maxeirxp parameters must be configured explicitly (even if configured
to the default value).